After setting the Christmas tree this, a section of the builtin lights weren’t turning on and found two of the wires had been chewed through.
I didn’t want to have to throw out the whole tree so I set about fixing it. I wasn’t looking forward to it though as I thought I would have to solder the wires together and cover them with heat shrink tubing… a process that was going to be very annoying under a Christmas tree. I debated just taping them together with some electrical tape but I didn’t want to deal with it maybe coming loose while taking it in and out of storage.
Fortunately while googling for some tips, I came across these solder seal wire connectors which made the process a whole lot easier.
